Panasonic 308 Installation Instructions Manual page 167

DES
FF-7 TR6 mode
3 - 7 TRS (Toll restrictian svstem)
mode
This is to set toll restriction
for a telephone.
There are 7 types of setting for
each outside
line connected
to
the system in the case
of
each telephone.
In that restrictions can be set for daytime and
nighttime separately, it is also possible to
control expensive telephone charges.
Toll restriction implemented here is done by
determining whether or not the call is
allowed depending on the number dialed by
means of the code table in the main memory
(toll number- area number- telephone
number).
Below is shown the structure of a simple TRS
system.
SECTION 400 (Version 3.0)
Issue 1 January 1990
FR-l#- l#-(0 or l)#
Setting restriction determining method
for Long distance, calls
ifis
specified which of the following restrictions is
determined depending on whether the first digit
dialed from extensions set as types 3 - 6 is 1 or 0.
(X = 0-9.P = 0orl.N = 2-9)
g& opx-xXxXx
Restrict (Not determined by
table)
AX-xXxXx Allow (Not determined by
table)
l#: ~-xXxXx Determined by office code
table
Note 1: For the system installation area it is
necessary to specify either + 7 Area or Non
+ 1 Area.
FF7- 1 B-2%-(0 or l)#
Dialing restriction during incoming call
It is specified whetherthe dial signal can be sent
out to outside lines which has received an
incoming calls from extensions set as types 3 - 6.
The dial signal is sent out while the call is in
progress after it has been answered, and at such
times the call sent is not restricted according
to
the dialing contents [set functions].
The call sent is subjectto restriction irrespective of
the setting when the FLASH key is pressed down
after the telephone conversation.
0%: Not possible to dial during conversation after
incoming call answered
18: Possible to dial durinu conversation after
incomins call answered.
-56-