Atv (Analogue)/Dtv (Digital) Buttons - Sharp Aquos LC-40LE820X Operation Manual

Watching TV

ATV (Analogue)/DTV (Digital) buttons

Use the following buttons on the remote control to
operate the menu.
ATV: Press to switch to analogue TV mode. After
switching from digital TV or external input mode to
analogue TV mode, the TV jumps to the most recently
viewed analogue channel.
DTV: Press to switch to digital TV mode. After
switching from analogue TV or external input mode
to digital TV mode, the TV jumps to the most recently
viewed digital TV channel.
40
40LE820X_en_au.indd 40 40LE820X_en_au.indd 40
When you watch the TV for the fi rst time
When the TV powers on for the fi rst time after
purchase, perform the auto installation.
ATV (Analogue TV)
You can run the auto installation to set channels
automatically.
To watch the analogue TV, select "Auto
1
installation" from "Setup" menu. (See page 19.)
After setting the channels, you can select a
2
channel using CH r / s or 0-9 on the remote
control unit. (See page 20.)
DTV (Digital TV)
When the TV accesses to DTV mode for the fi rst time,
you need to run the auto search. To scan all available
services in your area, follow the procedures below.
To watch DTV broadcasts, select "Digital
1
search" from "Auto installation" menu. (See
page 17.)
After setting the channels, you can select a
2
channel using CH r / s or 0-9 on the remote
control unit. (See page 20.)
2010/06/18 16:12:13 2010/06/18 16:12:13