Quick Start - Shark S3550 Owner's Manual

Quick Start

1
3
ASSEMBLE
1
Insert the mop handle into the
pump actuator (the tube that leads
to the tank). Push the mop handle
and pump actuator together in
until you hear it click into place.
2
Select a mop head and cleaning
pad. Fit one side of the pocket
onto the head first, then using
the lavender loop, pull the pocket
over the head. Attach the quick
fasteners on the top of the pocket
to secure in place.
3
Snap the mop head into the base to
secure it. Press the release button
to exchange mop heads.
TOLL FREE: 1-800-798-7398
When assembling your steam mop
there may be a little water in or around
the water tank. This is because we test
all our steam mops 100% before you
buy them, so you get a quality
Shark Steam Mop.
®
2
4
FILL
4
Lay the mop on the floor or on
a counter top and remove the
water tank cap by turning counter
clockwise. Fill the water tank using
the filling flask. Do not overfill the
water tank. Replace the water cap
and tighten.
IMPORTANT: Make sure your floors
are sealed. Before using the Steam
Mop consult page 4 for more
information.