Lubrication - Husqvarna CD48i Operator's Manual

General
When lubricating with grease, unless otherwise
stated, use only good quality molybdenum disulphide
grease. Grease from well-known brand names usually
maintains a good quality.
For daily use, the machine should be lubricated twice
weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts
or the drive surfaces on the belt pulleys. Should this
happen, attempt to clean them with spirits. If the belt
continues to slip after cleaning, it must be replaced.
Gasoline or other petroleum products must not be
used to clean belts.
Deck spindle - Tunnel deck only.
Lower the cutting deck completely.
Lubricate with a grease gun, one zerk, 2-3 strokes.
IMPORTANT INFORMATION
Use minimal lubrication and remove excess
lubricant so that is does not come into contact
with belts or belt pulley drive surfaces.

LUBRICATION

Deck spindle
8011-732
21
-
English