Table of Contents
Advertisement
Deck belt
Deck belt removal
Park on a level surface. Apply park brake.Lower the
deck into the lowest cutting position.
1.
Remove foot plate and belt shields.
2.
Using a ratchet and socket on the spring idler
bolt, relieve the tension on the belt.
3.
Remove any dirt or grass that may have
accumulated around the cutter housings and
entire deck surface.
4.
Carefully roll the belt over the top of the cutter
housing pulleys.
5.
Remove the belt from around the electric clutch
on the engine shaft and off the deck.
Deck belt installation
1.
Wrap the deck belt around the electric clutch
pulley that is located on the engine shaft.
2.
Route the belt forward between and up onto
the deck.
3.
Place belt around spring loaded idler pulley.
4.
Wrap the belt around the stationary idler pulley
and around the mandrel housings.
5.
Push inward on the idler arm and carefully
route belt over stationary idler pulley. Once belt
is properly routed, slowly release idler arm to
tension belt.
6.
Double check belt routing to make sure it
matches the routing decal, and the belt does
not have any twist. Correct as needed.
7.
Adjust tension.
8.
Replace belt shields on both mandrel housings
and secure with fasteners.
18
-
English
MAINTENANCE
Slackening the belt tensioner
IMPORTANT INFORMATION
For ease in installing the deck belt, refer to
the routing decal on bottom of seat.
8011-622
Advertisement
Table of Contents
