Attaching The Stand Unit - Sharp LC-70LE735X Aquos Operation Manual

Preparation

Attaching the stand unit

• Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1
Confirm that there are twelve screws (eight long
screws and four short screws) supplied with the
stand unit.
2
1 Set the supporting post for the stand unit onto
the polystyrene foam.
2 Attach the stand base to the supporting post.
3 Insert and tighten the eight screws into the
eight holes on the bottom of the stand base.
• Hold the stand unit securely with one hand, and
then tighten the screws.
Stand base
Supporting post
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the TV.
Improper installation may result in tilting of the TV set.
4
NOTE
Long screws
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch your
TV front
Soft cushion
Insert and tighten the four screws into the four
holes on the rear of the TV.
Short screws
fingers between the TV set and the floor.
7