Before Use - Teac PD-H01 Owner's Manual

Before use

Q Precautions for placement
o Do not put anything on top of the unit .
o Avoid placing the unit in direct sunlight, close to a source of heat or in other similar conditions .
Do not place the unit on top of an amplifier or other equipment that might generate heat that
exceeds the operating temperature range of this unit . Doing so could cause discoloration, defor-
mation or malfunction . (This unit can be placed on top of a TEAC A-H01 without problem . )
o Avoid locations that are subject to vibrations or exposed to excessive dust, cold or moisture .
o Place the unit in a stable location near the audio system that you will use with it .
o Do not move the unit during use .
o The voltage supplied to the unit should match the voltage printed on the AC adapter . If you are
in any doubt regarding this matter, consult an electrician .
o As the unit could become warm during operation, always leave sufficient space around it for
ventilation . When placing this unit, position it so that it is at least 20 cm (8") from walls and other
devices in order to allow good heat dissipation . When installing it in a rack, leave at least 15 cm
(6") open above the unit and 10 cm (4") behind it .
o Do not open the body of the unit as this might result in damage to the circuitry or cause elec-
tric shock . If a foreign object should get inside the unit, contact your dealer or TEAC customer
service .
o When removing the power plug from the wall outlet, always pull directly on the plug; never
yank on the cord .
o When the unit is turned on, if a TV is turned on nearby lines might appear on its screen depend-
ing on the characteristics of the TV broadcast signal . This is not a malfunction of the unit nor of
the TV . If this occurs, press the STANDBY/ON button to put the unit in standby .
Q Use precaution
Listening to anything at a high volume for a long time could be harmful to your hearing . In order
to protect your ears, be careful not to set the volume too high when listening with headphones for
long periods of time .
Cleaning
Wipe the acrylic part of the top cover with a soft cloth . Clean dirt from panel surfaces by wiping
them with a soft cloth that has been slightly dampened with a diluted neutral cleaning fluid .
o Do not use chemical cleaning cloths, thinner or similar substances as they could damage the
surface of the unit .
Q For safety, disconnect the power plug from the outlet before cleaning.
8
PD-H01_OM_EFS_vA_CS6.indb 8 13/01/25 17:06