Service And Adjustment; Mower - Husqvarna 968999250 Operator's Manual

Husqvarna lawn mower operator's manual

Hide thumbs

Table of Contents

WARNING

BEFORE PERFORMING ANY SERVICE

OR ADJUSTMENTS:

•

Set park brake to engaged position.

•

Place PTO switch in the disengaged

position (pressed down).

•

Turn ignition key "OFF" and remove

the key.

•

Make sure the blades and all moving

parts have completely stopped.

•

Disconnect spark plug wire from

spark plug and place the wire where

it cannot come in contact with the

plug.

MOWER

TO LEVEL DECK

Adjust the deck while the mower is on a level

surface. Make sure the tires are inflated to the

correct pressure (see "SPECIFICATIONS"

section in this manual). If tires are under or over

inflated, you can not properly adjust your deck.

NOTE:

It may be easier to adjust the front lift

linkages by removing the floor pan before any

adjustments are made

SIDE-TO-SIDE ADJUSTMENT (See Figs. 13

and 14)

•

Raise the deck into the highest cutting

position (4 1/2")

•

Measure height from the bottom edge of

the deck to the ground at both front

corners. Distance "A" at both corners

should be the same.

•

If adjustment is necessary, make

adjustment to one side the deck only

•

To raise one side of the deck, using a 9/16"

wrench, tighten the hex nuts on both the

front and rear lift linkages (be sure to

tighten equal amounts).

•

To lower one side of the deck, reverse

previous step.

•

Recheck measurements after

adjustment.