Husqvarna 968999250 Operator's Manual page 23

TO TRANSPORT (See Fig. 7)
When pushing or pulling the mower, be sure to
engage the IZT (Integraded Zeroturn Transaxle)
bypass linkages. The IZT bypass linkages are
located on the rear of the frame, below the rear
engine guard.
CAUTION
Do
not tow this vehicle, it may cause dam-
age to the drive system.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into
the slots and release so that it is held in
the bypass position.
• To reengage the IZT's to drive, reverse
the above procedure.
WARNING
Do
not tow any trailers, etc. with this mower.
They may jackknife or overturn causing
damage to the mower and possibly serious
injury to the operator.
OPERATION
1. HEAD INSIDE OF REAR DECK
2. IZT BYPASS LINKAGE IN DRIVE POSITION
1. HEAD OUTSIDE OF REAR DECK
2. IZT BYPASS LINKAGE IN BYPASS POSITION
23
1
FIGURE 7
1. IZT BYPASS LINKAGE
1
2
FIGURE 7A
1
2
FIGURE 7B
CZ-10
CZ-11
CZ-12