Husqvarna 968999250 Operator's Manual page 32

Husqvarna lawn mower operator's manual
Table of Contents

Advertisement

TO SHARPEN BLADE (See Fig. 9)
WARNING
When it is necessary to raise the
mower for any repair or service, use
jackstands to provide adequate sup-
port. DO NOT rely on hydraulic or me-
chanical jacks
Care should be taken to keep the blade bal-
anced. An unbalanced blade will cause exces-
sive vibration and eventual damage to mower
and engine.
The blade can be sharpened with a file or
on a grinding wheel. Do not attempt to
sharpen while on the mower.
To check blade balance, you will need a
5/8" diameter steel bolt, pin, or a cone
balancer. (When using a cone balancer,
follow the instructions supplied with
balancer.)
NOTE: Do not use a nail for balancing the blade.
The lobes of the center hole may appear to be
centered, but are not.
Slide blade on to an un-threaded portion
of the steel bolt or pin and hold the bolt or
pin parallel with the ground. If the blade
is balanced, it should remain in a
horizontal position. If either end of the
blade moves downward, sharpen the
heavy end until the blade is balanced.
CUSTOMER RESPONSIBILITIES
3
1. BLADE
2. CENTER HOLE
3. 5/8" BOLT OR PIN
32
2
1
FIGURE 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z4818bia

Table of Contents