JVC KD-SC800R Service Manual page 15

2.2.9 Removing the trigger arm
(See Figs.19 and 20)
• Prior to performing the following procedure, remove the top
cover, connector board and clamper unit.
(1) Turn the trigger arm in the direction of the arrow to release
the joint k and pull out upward.
CAUTION:
When reassembling, insert the part m and n of the trigger
arm into the part p and q at the slot of the chassis rivet
assembly respectively and join the joint k at a time.
2.2.10 Removing the top plate assembly
(See Fig.21)
• Prior to performing the following procedure, remove the top
cover, connector board, chassis unit, and clamper assembly.
(1) Remove the screw H.
(2) Move the top plate assembly in the direction of the arrow to
release the two joints r.
(3) Unsolder the wire marked s if necessary.
Chassis rivet assembly
Fig.19
Trigger arm
Part m
Chassis rivet
assembly
Fig.20
Top plate assembly
H
Fig.21
KD-SC800R
Joint k
Trigger arm
Part p
Part q
Part n
Joints r
s
(No.49820)1-15