Storage; Troubleshooting - NewAir AI-215 Series Owners Manual & Instruction Manual

4. After the self-clean program is completed, drain out the water by
unplugging the drain cap on the side. Then close the drain cap
5. Unplug the unit and add fresh water into the interior tank up to the water
level mark.
6. Replug the unit to the power supply, and rerun the self-cleaning program
again as describe in Step 3.
7. When the self-cleaning program is completed, unplug the uni and drain out
the water by unplugging the drain cap on the side.
8. Dry the interior and exterior with a soft cloth.
9. Tighten the drain cap. Replace the ice basket and plug the unit in again.
To remove the build-up of calcium or other impurities, add a capful of vinegar
or lemon juice to the water in the reservoir and run for two or three ice-making
cycles. Drain and refill the reservoir with clean, warm water. Run two more
cycles to rinse the vinegar or lemon-juice.
When the machine is not in use, open the water drain cap to completely drain
the water reservoir.

STORAGE

Before storing your ice maker, clean it according to the directions above and
allow it to dry thoroughly – at least 24 hours – in order to prevent the growth
of mold or mildew.
Store your ice maker in the original packaging, or cover with a soft cloth or
plastic sheet.

TROUBLESHOOTING

Problem
The "ADD WATER"
indicator light is on.
There is not enough
water in the tank.
NEWAIR AI-215 SERIES PORTABLE ICE MAKER
Possible Cause Solution
Press "POWER" to turn
off the unit. Fill the
reservoir with water.
Press "POWER" to
restart.
9