Toshiba 40RL900A Owner's Manual page 17

NOTE:
• The Security Key must adhere to these
conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex
characters
• There is only one key ID to set for WEP
encryption.
Press B or b to highlight Done and press
OK.
NOTE:
• If Network Name is not displayed, see
Manual Setup below to set Network Name
before pressing Done.
• If BACK is pressed before Done is selected,
settings are not saved.
When the message "Wireless confi guration
is complete. " appears on screen, press OK.
The screen will skip to step 14.
m
In step 11, when you select Manual Setup;
Press OK, and the Manual Setup screen
will appear. Press B or b to select Network
Name and press OK.
The Software Keyboard window will appear
(page 36).
Input the Network Name by using the
Software Keyboard.
To save your setting, press the BLUE button.
Press B or b to select Authentication and
then press C or c to select Open System,
Shared Key, WPA-PSK or WPA2-PSK.
Press B or b to select Encryption, and then
press C or c to select None, WEP, TKIP or
AES.
NOTE:
• Certain encryption types are only
compatible with specifi c authentication
types.
- When Authentication is Open System, only
WEP or None is compatible.
- When Authentication is Shared Key, only
WEP is compatible.
- When Authentication is WPA-PSK or WPA2-
PSK, only TKIP or AES is compatible.
• When incompatible Authentication/
Encryption pairings are detected, a
warning message will be displayed, and
no connection attempt will be made until
the incompatibility is resolved.
• There is only one key ID to set for WEP
encryption.
Press B or b to select Security Key and
press OK. Input the Security Key by using
the Software Keyboard (page 36).
To save your setting, press the BLUE button.
This item is grayed out when Encryption is
None.
When Encryption is WEP, Key ID setting is
available. Press B or b to select Key ID and
press C or c to select 1(default), 2, 3 or 4.
Press B or b to select Done and press OK.
When the message "Wireless confi guration
is complete. " appears on screen, press OK.
NOTE: Settings are not saved if BACK is
pressed before Done is selected.
n
The Advanced Network Setup screen will
appear.
When the DHCP function of the router
connected with this TV is On, you can set
Auto Setup to On or Off . (This should
usually be set to On.)
When the DHCP function of the router is
Off , set Auto Setup to Off , and set the IP
Address DNS address(es) manually.
Advanced Network Setup
IP Address Setup
Auto Setup
IP Address
Subnet Mask
Default Gateway
DNS Setup
Auto Setup
Primary DNS Address
Secondary DNS Address
MAC Address
You can view the fi xed MAC address for the
TV and for the Dual Band WLAN Adaptor, if
one is installed.
Press B or b to select Next.
17
SETTING UP YOUR TV
On
XXX . XXX . XXX . XXX
XXX . XXX . XXX . XXX
XXX . XXX . XXX . XXX
On
XXX . XXX . XXX . XXX
XXX . XXX . XXX . XXX
00:11:22:33:44:55
Next