Toshiba Satellite U500 Maintenance Manual page 219

Installing the LCD unit / FL inverter
To install the LCD unit / FL inverter, follow the steps below and refer to Figures 4-44 to 4-
49.
1. Connect the LCD cable to the LCD unit.
2. Secure one piece of tape on LCD cable connector.
3. Seat two LCD supports on the LCD and secure them with the following screws.
• M2×2.5L FLAT HEAD screw
CAUTION: When installing the LCD support, do not mistake the left for the right and
vice versa. "L" for the left, "R" for the right and "UP" for the up of the
bracket are marked on the bracket.
5. Seat the LCD unit on the display cover.
6. Secure the following screws to attach the LCD unit.
• M2.5×4L FLAT HEAD screw
7. Connect the FL cable to connector CN1 and the HV cable to connector CN2, then
fix 1 piece of tape on the HV cable.
8. Install the FL inverter in place.
9. Seat the LCD mask pressing firmly all around to secure the latches.
10. Secure the LCD mask with the following screws.
•
M2×5L
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D
×4
(K) screw
4 Replacement Procedures
×6
×2
Maintenance Manual 4-77