3. Charge for 24 to 48 hours (battery may
be charged for up to 72 hours with no
harmful effects).
An engine run time of at least 8 hours is
required to charge a fully discharged battery.
To Remove Battery from Unit
1. Remove wing nuts from battery U-bolt.
2. Disconnect battery from wiring.
ENGINE/BLADE CONTROL
To adjust engine/blade control:
1. Loosen cable nuts away from bracket.
Figure 16
2. Squeeze z-bend bracket at engine end
of cable toward front of unit and hold in
place.
Robin
3. Pull cable down from bracket until there
is no slack in cable.
Briggs & Stratton
No slack
4. Tighten lower
cable nut to 1/
8" (3mm)
below bracket.
Release z-
bend bracket.
5. Tighten upper
cable nut until
bracket is secure
between cable
nuts.
6. Engage engine/blade control. Measure
distance between middle of z-bend and
cable bracket. Measurement should be
as shown below.
1.240" (3.15 cm)
7. If proper measurement cannot be
achieved, contact your local dealer.
GB - 19
1.325"-1.788"
(3.4 - 4.5 cm)
Briggs & Stratton
Robin