Cub Cadet 3000 Series Service Manual page 40

Install the sleeve into the valve housing.
Figure 25.
Using caution to retain the races, bearing and sleeve
in the valve housing, carefully turn the assembly over
and set it on a clean flat surface. Together, the hous-
ing, races, bearing and sleeve create a groove into
which the quad seal can be installed. Lubricate and
install the quad seal in its seat through the input end
of the valve housing.
CAUTION: When installing, be sure the quad seal is
not twisted.
Figure 26.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
After the seal is installed, turn the valve housing over
and remove the sleeve, races and bearing.
Figure 27.
Turn the valve housing over and press the dust seal
into its bore, located in the face of the valve housing.
NOTE: The lip of the dust seal must point away from
the valve housing.
Figure 28.
6 - 7
Cub Cadet 3000