Fender Assembly Removal And Reinstallation - Cub Cadet 3000 Series Service Manual

Fender Assembly Removal and Reinstallation

1. Slide the seat back and remove the front two pan
torx head screws using a T30 torx.
2. Slide the seat forward and remove the rear two
pan torx head screws using a T30 torx.
3. Pivot the seat assembly to the side and
disconnect the seat safety switch. See figure 1.
NOTE: Be careful not to scratch the fender with
the seat support brackets. It is advisable to use a
towel or cloth under the seat when pivoting the
seat.
4. Remove the seat from the tractor. See figure 1.
Torx Screws
Seat Safety
Switch
FIGURE 1.
5. Remove all the hex bolts securing the three foot
pedals to the right side of the unit using a 9/16
socket. See figure 2.
Reverse
Pedal
Hex Bolts
FIGURE 2.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
6. Remove the hex bolt securing the differential lock
FIGURE 3.
7. Remove both rubber floor pads from the running
8. Lift the hood and remove the battery cover.
9. Remove both side panels from the tractor by
10. Loosen all four plastic wing nuts holding the dash
11. Pull the dash screen towards the rear of the unit
Brake
Pedal
Hex
Bolts
Forward
Pedal
FIGURE 4.
3 - 1
out pedal on the left side of the unit using a 9/16
socket. Remove the "E" clip and the nylon flange
bearing from the pivot shaft.
Differential Lock
Out Pedal
E-Clip
boards. See figure 4.
raising the latches horizontally and turning the
latches 1/4 turn. See figure 4.
panel screen in place. See figure 4.
and out of the dash panel. See figure 4.
Wing
Nut
Side Panel Latch
Cub Cadet 3000
Hex Bolt
Nylon Flange
Bearing
Side Panel Latch
Dash
Screen
Rubber Foot Pads