Manual Transport - Husqvarna 115 127127 IR Operator's Manual

Manual Transport

When pushing or pulling the mower, engage the EZT
(Integrated Zeroturn Transaxle) bypass linkages. The
EZT bypass linkages are located on the rear of the
frame, below the rear engine guard.
1. Raise the deck into the highest cutting position.
2. Pull the EZT bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3. To reengage the EZT's to drive, reverse the
above procedure.
load the machine into truck or trailer by driving up
ramps in low gear. DO NOT lIfT! The machine is not
intended to be lifted by hand.
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
OPERATION
Bypass linkage, EZT engaged
Bypass linkage, EZT locked in the bypass position
8058-032
8058-032
33
Husqvarna-