Deck Outer Spindle; Engine Oil - Husqvarna 115 127127 IR Operator's Manual

Deck Outer Spindle

lubricate using a grease gun, one zerk, each side 2-3
strokes. Use only good quality bearing grease.
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
engine. Allow the engine to cool to a
safe temperature before draining.

Engine Oil

Engine Oil Filter
• Drain the engine oil in accordance with the work
description under the heading Engine Oil/Change
Engine Oil.
• Remove the oil filter. If necessary, use a filter
remover.
• Wipe new, clean engine oil onto the seal for the
new filter.
• Mount the filter by hand with +¾ turn.
• Run the engine warm, then check that there are
no leaks around the oil filter seal.
• Check the oil level in the engine, fill if necessary.
The oil filter holds 0.1 qt (0.1 liters) of oil.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in nature;
it should always be disposed of at a workshop
or appropriate disposal location.
Avoid skin contact; wash with soap and water
in case of spills.
lUBRICATION
Deck outer spindle (with belt shield removed)
Changing the oil filter
8061-025
8011-734
53
Husqvarna-