Tape Operation - Panasonic PVQ-1312B Operating Instructions Manual

Tape Operation

Search System is ...
Each time a recording is made, an invisible index mark is placed on the tape.
When timer recordings are made, program index and information are also included.
These index marks can be used to access or scan recordings.
Index Search
Go directly to the desired recording.
1
I NDEX SEARCH
ENTER I NDEX NUMBER : 1
US I NG 1- 9 KEYS
FORWARD SEARCH : FF
REVERSE SEARCH : REW
NEXT : SEARCH
EX I T : STOP
2
I NDEX SEARCH 3
I NDEX SEARCH
3
I NDEX SEARCH
FORWARD SEARCH : FF
REVERSE SEARCH : REW
To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1 2 3
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1 2 3
NOTE: indicates start points of each recording.
Notes
• Make each entry within 10 seconds, or the Index
Search mode will be canceled.
• If Index Search is started very close to an index
mark, that index mark may not be counted in the
search.
22
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Press SEARCH in
Playback or Stop
mode to display
INDEX SEARCH
screen.
Press number
keys to select the
recording number.
• To calculate number,
see below.
Press FF or REW
to start search.
• Play begins at search
end. To search
forward or back 1
index, press FF or
REW while screen left
in displayed (10
seconds).
4 5 6 7
4 5 6 7
Program End Search
Locates end point of recording for continuity.
1
Press SEARCH twice in Playback
or Stop mode to display
PROGRAM END SEARCH screen
.
2
PROGRAM END SEARCH
SEARCH START : FF
EX I T : SEARCH
Example of Program End Search operation.
Fig.1
PLAYBACK DIRECTION
Program 1
Press SEARCH button
FF
Fig.2
Program 1 BLANK
Press SEARCH button
Fig.3
If search exceeds a few seconds in BLANK area.
Press SEARCH button
Program 1
End Point
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
Press SEARCH button
Notes
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.
Press FF to
start search.
Program 2 or BLANK
End Point
Program 2
BLANK
End Point
FF
Program 2
BLANK
FF