Technical Data - Husqvarna 339XP Operator's Manual

Engine
3
Cylinder volume, cu.in/cm
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at 8 500 rpm, ml/min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Standard bar length, inches/cm
Recommended bar lengths, inches/cm
Usable cutting length, inches/cm
Chain speed at max. power, m/sec
Pitch, inch
Thickness of drive link, inch/mm
Number of teeth on drive sprocket
Type Inch
S36x 3/8"
91VS
H30 0,325"
95VP
34
– English

TECHNICAL DATA

336
2,15/35,2
1,5/38
1,22/31
2 800
1,5/ 9 600
SEM
CD
NGK BPMR 7A
Champion RCJ 7Y
0,02/0,5
Zama
C1Q EL20
0,76/0,36
3-7
0,43/0,2
Automatic
8,4/3,8
13"/33
12-16"/30-41
11-15"/28-38
18,3
0,325"/8,25
0,050"/1,3
7
1
5
Inch/mm Inch/mm
0,050"/1,3 5/32" /4,5
0,050"/1,3 3/16" /4,8
´®z+H*•¶5@¨
Recommended original and replacement
bar and chain combinations
Following is a list of recommended cutting equipment for
the Husqvarna Model 336. The combinations of
powerhead, bar and chain have been investigated in
accordance with the kickback requirements of ANSI B
175.1 – 2000. The guide bar nose radius is determined by
either the maximum number of teeth in the nose sprocket or
the corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers
recommendations. There may be other combinations
available, which will also achieve kickback protection.
As we are listing the maximum guide bar nose radius, you
may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose
guide bars of the same pitch and having the same number
of of sprocket teeth may be considered to have equivalent
kickback energy. A hard nose bar having the same length
and nose radius as a sprocket-nose bar may be considered
to have equivalent or less kickback energy than the
sprocket-nose bar.
Low kickback saw chain is a chain which is has met the
kickback performance requirements of ANSI B 175.1 safety
requirements for gasoline-powered chain saws when tested
on the representative sample of chain saws below 3.8 cu.
in. specified in ANSI B 175.1. We recommend that you as
replacement use the listed chains or "Low kickback saw
chains" which are available at your dealer.
Guide bar
Length Pitch
inch inch
12 3/8
14 3/8
16 3/8
13 0,325 10T
15 0,325 10T
16 0,325 10T
Angle Angle
60° 30°
60° 30°
Saw chain
Max nose
radius
9T Husqvarna S36x or Oregon 91VS
9T
9T
Husqvarna H30 or Oregon 95VP
Angle Inch/mm
0° 0,025"/0,65
10° 0,025"/0,65
L
Inch/cm: dl
12"/30:45 14"/34:52
16"/41:56
13"/33:56 15"/38:64
16"/41:66