›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Middle rear head restraint
ä
First read and observe the introductory information and safety warn-
ings
on page 59.
Applies to vehicles using the TOP TETHER system.
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
60
Using the system
Fig. 48
Rear seats: middle head re-
straint
1
» Fig.
48, simultaneously
using a flat screwdriver with a
2
Rear seats
Ð
Adjusting seats in forward/back direction
Fig. 49 Releasing at the front/rear
›
Pull the lever
» Fig. 49
up in the direction of arrow
A
in direction of arrow
and move the seat into the desired position
2
WARNING
The following guidelines must be observed
tion for the occupants on the rear seats.
Adjusting the angle of the seat backrest
Ð
›
Pull the lever
» Fig. 50
and adjust the required inclination of the seat back-
1
rest.
or on the release loop
1
.
3
» page
130, Correct seated posi-
Fig. 50
Adjusting the seat backrest
Ð
£