60045_10504_pg.3.pdf
QUICK START INSTRUCTIONS
5
Mount system, aim with
laser, switch to off.
6
Set surveillance functions:
MODE: 24 HR or daylight only.
DELAY: 1,5,or 20 minutes delay
between photos.
7
Set test switch to (IR test), close
cover, turn unit on and wait at
least 1 min. for the unit to warm
up. Step aside and wait for the
light to go out. Any motion will
activate the blinking red light.
Switch unit off, return test switch
to (normal).
For more help call: Moultrie Customer Service (205) 664-6700
8
Lock case, switch unit on and
wait at least 1 min. for the unit
to warm up. If you want to test
fire system and take the first
picture, wait for delay time to
expire and walk in front of unit.
if not, do not walk in front of
unit!
If you have any problems, check:
•Are batteries fresh and installed properly?
•Do you have enough daylight in location?
•Is the camera lens open?
•Is the camera plugged in?
•Is the film loaded properly?
•Is the test switch in normal?
•Is the power switch on?
•Is the unit in the delay period?
•Change batteries and set up again.
page 3