Moultrie 35mm Instruction Manual page 11

60045_10504_pg.10.pdf
SETTING UP GAME SPY CAMERA SYSTEM
Attaching Control Box To a Tree or Pole
Using a bungee cord, attach the camera system to a tree or pole approximately 2.5 or 3 feet
above the ground. Make sure the camera is secure and will not move from the desired location.
Selecting Operation Mode
You can choose two types of operation modes to trigger the system. Slide the mode switch to the
appropriate setting.
• (24 hr. mode), The system will take a picture regardless of light situation 24 hours a day.
• (Day mode), during bright daylight hours
Selecting Delay Time
You can select any of three delay times. You can select 1 minute, 5 minutes or a 20 minute delay time
between pictures. Slide the switch to the appropriate time delay. The delay mode will not
automatically change after the switch has been changed, until the next picture is taken. Press the
camera test button to override.
Testing Camera
When the Camera Test Button (22) is pressed it will activate the camera to make sure the camera is
working properly. This will take one picture every time the button is pressed and the event counter will
add one digit to the Event Counter LED (13). Test will also work without film loaded.
Testing Infrared
To test IR Sensor, slide the Sensor Test Switch (18) upward to the "IR Test" setting and close the cover.
The IR sensor detects heat and motion, if working the IR sensor will activate a red LED light. The sensor
will work without triggering the camera. After testing the IR sensor, return the switch to "Normal"
position for normal operation. This mode is used to also aim the control box by walking in front of the
Game Spy system and noting when the red light comes on, indicating you are in the field of view.
MODE
24 HR
DAY
DELAY
20
5
1
CAMERA
TEST
TEST
IR TEST
NORMAL
page 10