Moultrie 35mm Instruction Manual page 12

60045_10504_pg.11.pdf
Aiming Control Box
To aim your camera system, open front cover, slide the Sensor
Test Switch (18) upward to the "IR Test" setting and close cover.
Position and aim the system at your desired target area. Move
around to the front of the control box and check when the IR
sensor activates (with a red light). If it is not aimed properly
repeat the process until your desired target area is achieved.
Return Sensor Test Switch (18) to the "Normal" position after
system is aimed. Note: The maximum range of the IR Sensor
(7) is 26.2 ft.
Loading Film
To Load film, you must first turn the external ON/OFF switch to
OFF. Open the control box cover and remove the camera. To
remove the camera, Unscrew the camera mounting bolt from the
control box camera ledge and unplug the Camera Power Plug
(25) from the Surveillance System Port (8). Now the camera can
be removed. Open the Back Door (24) by sliding the Back Door
Latch (28) upward and gently swinging the door open. Insert
the film cartridge into the Film Chamber (19). Make sure the film
is completely inside the chamber. Pull the film leader out and lay
it across the Film Take-up Spool (21) until it extends to the Film
Tip Mark (22). Make sure that the film leader also engages
Film Sprocket (20). Check the film and make sure it is in the film
chamber completely. Close the Back Door (24) firmly. The
Exposure Counter (23) will show "S". Continue pressing the
Shutter Release Button (1) until the Exposure Counter (23)
shows the number "1". You are now ready to take a picture.
Important: Make sure the lens cover is closed all the time until
the camera has been securely connected to the control box
via the cable provided.
page 11