Impecca ITAC-08KS User Manual page 5

⍟ Stop operation and close the window
in storm or hurricane .
• Operation with windows opened may
cause wetting of indoor and soaking of
household furniture .
⊘ Do not place obstacles around air-inlets
or inside of air-outlet .
• It may cause failure of appliance
or accident .
⊘ Do not use strong detergent such as
wax or thinner to clean the unit .
Use a soft cloth .
• Appearance may be deteriorated due to
change of product color or scratching of
its surface .
⍟ Use caution when unpacking and
installing . Sharp edges can cause injury .
CAUTIon eleCTRICAl InFoRMATIon
• Be sure your electrical wiring is adequate for the model
you have chosen . This information can be found on the
serial plate, which is located on the side of the cabinet and
behind the grille .
• Be sure the air conditioner is properly grounded . To min-
imize shock and fire hazards, proper grounding is important . The
power cord is equipped with a three-prong grounding plug for
protection against shock hazards .
• Your air conditioner must be connected to a properly grounded
wall receptacle . If the wall receptacle you intend to use is not ade-
quately grounded or protected by a time delay fuse or circuit break-
er, have a qualified electrician install the proper receptacle .
• Ensure the receptacle is accessible after the unit installation .
The power supply cord contains a current device that senses damage to
the power cord . To test your power supply cord do the following:
1 . Plug in the Air Conditioner .
2 . The power supply cord will have TWO buttons on the plug head . Press the
TEST button, you will notice a click as the RESET button pops out .
3 . Press the RESET button, you will notice a click as the button engages .
4 . The power supply cord is now supplying electricity to the unit .
(On some models this it also indicated by a light on the plug head .)
noTes:
• Do not use this device to turn the unit on or off .
• Always make sure the RESET button is pushed in for correct operation .
• The power supply must be replaced if it fails reset when either the TEST button is pushed, or it cannot be reset .
• A new power supply can be obtained from the product manufacturer .
• If power supply cord is damaged, it cannot be repaired . It MUST be replaced by one from the product manufacturer .
CAUTIon
⍟ Hold the plug by the head of the power
plug when unplugging unit .
• Otherwise, it may cause electric shock
and damage .
⊘ Ensure that the installation bracket of the
outdoor appliance is not damaged due to
prolonged exposure .
• If bracket is damaged, the unit can fall and
cause damage, injury or bodily harm .
⊘ Do not place heavy object on the
power cord and ensure that the cord
is not compressed .
• There is danger of fire or electric shock .
⍟ If water enters the unit, turn the unit off at
the power outlet and switch off the circuit
breaker . Isolate supply by taking the pow-
er-plug out and contact a qualified service
technician immediately .
3
⍟ Turn off the main power switch when
not using the unit for a long time .
• It may cause failure of product or fire .
⍟ Always insert the filters securely .
Clean filter once every two weeks .
• Operation without filters may cause
failure .
⊘ Do not drink water drained from
air conditioner .
• It contains contaminants and could
make you sick .
noTe:
The power supply cord with this air conditioner con-
tains a current detection device designed to reduce the risk
of fire . In the event that the power supply cord is damaged, it
cannot be repaired-it must be replaced with a cord from the
Product Manufacturer .