P7 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06
SeCtIon 3
Buttons & Indicators
Power Button
Press to turn the brewer power on and off.
add Water Indicator
— Fill the Cold Water Reservoir
Flashing Blue
with cold water until it reaches just under the rim
of the desired level – 6, 8, or 10 oz. of the Water
Level Guide.
handle Indicator
Flashing Blue
— The blue light flashes when the
minimum water amount of 6 oz. has been poured into
the Cold Water Reservoir. After adding your desired
amount of water (10 oz. maximum), lower the Cold
Water Reservoir Lid. The light will continue to flash
until you lift the Handle.
Brew Button
Flashing Blue — Indicates you are ready to brew.
Press the BREW Button.
Flashing Red — Indicates water is heating
(approximately 2 minutes).
Solid Red — Indicates brewing and dispensing of
beverage has begun.
(does not illuminate)
7
Your next Brew
When the brewing process is complete, the Add Water
Indicator light will appear. At this point you can begin
making the next beverage, or you can power off.
automatic Shut-off
As a safety feature, your brewer will automatically
shut off at any stage when it is idle for longer than 90
seconds. Press the Power Button to restart. If the
brewer shuts off while the BREW Button was flashing
blue, lift and lower the Handle to reset.
Drip Tray overfill Indicator
A red float will appear when the Drip Tray is almost
full. Carefully slide Drip Tray out and empty contents
into the sink.