Page 1
K150/ K150P CLEANING & START-UP PROCEDURE This procedure demonstrates how to properly ® clean and sanitize the Keurig K150/ K150P brewer This procedure should take approximately 30 minutes Tools Needed Clean & Sanitize Kit ( if available Available sink...
Page 2
Cleaning Carefully unplug brewer and bring to sink For K150 remove Reservoir and drain ( see F ig. 1 For K150P turn water OFF and disconnect water line ( see Fig. 2 Fig. 1 Fig. 2...
Page 3
Cleaning cont. Lift handle and remove any used K-Cup ® pods that may be present ( see F ig. 3 Fig. 3 Remove rear Door Hatch and locate drain tubes at rear of brewer and carefully drain ( see Fig. 4 CAUTION WATER MAY BE VERY HOT Fig.
Page 4
Cleaning cont. Remove all parts as shown below ( see Fig. 5 Clean and sanitize thoroughly per Clean & Sanitizing procedure ( see pg. 5 Follow up with wipes on all exterior of brewer CAUTION Sharp Needle Fig. 5...
Cleaning & Sanitizing Procedure Cleaning Solution 1. Prepare Urnex Rinza solution by adding 8 oz ( ) of Urnex Rinza concentrate to 1 gallon ( 240 ml 3.5 L of warm tap water ( or equivalent dilution 2. Mix well and use immediately 3.
Page 6
Running a Cleansing Brew Reassemble all parts removed ensuring that the Removable Float ( ) is installed correctly item Q K150: fill Reservoir with fresh water ( see Fig. 6 K150P: reconnect water line and turn valve ON ( see Fig. 7 CHECK FOR LEAKS Fig.
Page 7
Running a Cleansing Brew cont. Please wait until the water reaches the correct temperature ( less than three minutes see Fig. 7 Fig. 7 The LCD Display will change & notify when ready ( see Fig. 8 Fig. 8...
Page 8
NOTE: If available, an Urnex cleaning cup can be used for one of the Cleansing Brew cycles *Repeat Cleansing Brew 3 times* PROCEDURE COMPLETE! If you have any questions please contact Keurig Commercial Technical Support: 888-287-2739 option 5...