Icom IC-F9010 SERIES Operating Manual page 10

1
PREPARATION
D Analog and APCO P25 modes operation (Continued)
(Not available on Non-display types)
TONE/NAC CH SELECT KEY "T SEL"
➥ While in the analog mode, push to enter the continuous
tone channel selection mode, then select a desired tone
frequency/code setting using [CH Up]/[CH Down] or [CH
Up/Down]. After selecting, push this key again to set.
➥ While in the APCO P25 mode, push to enter the NAC
channel selection mode, then select a desired NAC set-
ting using [CH Up]/[CH Down] or [CH Up/Down]. After
selecting, push this key again to set.
➥ While in the mixed (digital and analog) mode, push to enter
the continuous tone channel selection mode, then select
a desired tone frequency/code setting using [CH Up]/[CH
Down] or [CH Up/Down]. After selecting, push this key to
set. After that, the NAC channel selection screen appears.
Select a desired NAC setting using [CH Up]/[CH Down]
or [CH Up/Down]. After selecting, push this key again to
set.
7
D APCO P25 mode operation
(Common operation)
ZEROIZE KEY "ZERO"
Push and hold for 1 sec. to zeroize the encryption key data
which is programmed by the key loader.
After zeroising, the transceiver cannot decrypt the encrypted
code.
SITE LOCK KEY "SLCK" (Trunking mode only) (p. 28)
Push to lock the transceiver to the current registered site.
When the Site Lock function is activated, roaming and the
background scan are inhibited.
Push again to turn the Site Lock function OFF.
(Simple/10-key and Non-display types operate differently)
ENCRYPTION KEY "DENC" (p. 56)
- The UT-125 /
aes des encryption unit
is required.
unit
❍ For Simple and 10-key types
Push to turn the Encryption function ON or OFF.
❍ For Non-display types
➥ Push and hold for 1 sec. to turn the Encryption function
ON.
➥ If the function is ON, push the key to turn it OFF.
or UT-128
des encryption