Hunter Set & Save 44377W Installation And Operation Manual page 47

icons and features, cont.
5. Span setting mode – allows you to adjust the system ON/OFF
cycle rate. The default setting is 2 (the system cycles ON or OFF
when the temperature is within 1
the set temperature.) The span setting can be adjusted if your
system is cycling too fast or too slowly.
Press and hold both the
SPAN appears. Use the
setting.
(Up will increase your cycle time by allowing the system to run longer;
Down will decrease your cycle time by causing the system to run for a
shorter length of time.)
Span settings remain the same for
settings. When batteries are installed, or the unit is RESET, the
span cycle will revert to 2.
o o
F (0.5
U and D buttons until the word
p OwN
U or D button to adjust the span
p OwN
HEAT and
47
C) above and below
cOOl system