Advertisement
1. Disconnect power to the ceiling fan by turning off the circuit breakers both to the
outlet box and to its associated wall switch location.
2. Find the empty lower switch housing that came with your Tribeca
not sure what this piece is, refer to your Tribeca
Note: If your Tribeca
fan is already installed, you will need to remove the fan
TM
only switch housing before proceeding. Refer to your Tribeca
3. On the light kit housing, find the three recessed trim bezel screws and remove
them. Remove the trim bezel. Do not discard these screws. You will reuse them.
Note: e illustrations in the manual assume you are installing the light kit with
the globe fitter. If you want to use the light kit without the globe, remove the
three globe fitter screws and the globe fitter. Retain the globe fitter and the screws
in case you want to use the globe fitter in the future.
4. read the wires from the light kit through the hole in the center of the switch
housing. Attach the lamp holder assembly to the switch housing. Use 2 #6-32 x
5/8 inch screws. Align the holes and tighten the screws.
5. Connect the black wire in the light to the black wire with white stripe in the fan.
Connect the white wire in the light to the white wire in the fan. Secure both wire
connections with the ceramic wire nuts provided.
6. Attach switch housing to fan using three side screws provided with the fan.
Recessed Trim
Globe Fitter
Bezel Screw
Screw
Globe Fitter
Trim Bezel
Step 3
fan manual.
TM
Switch
Housing
Step 4
TM
fan. If you are
TM
fan manual.
Steps 5–6
Advertisement
