Clock - Cadillac CTS 2011 Owner's Manual

5-8 Instruments and Controls
3. Press to scroll through and
select the appropriate
variance zone.
4. Press until the vehicle
heading, for example, N for
North, is displayed in the DIC.
5. Calibrate the compass. See
Compass Calibration
Procedure following.
Compass Calibration
The compass can be manually
calibrated. Only calibrate the
compass in a magnetically clean
and safe location, such as an open
parking lot, where driving the
vehicle in circles is not a danger.
Also, away from tall buildings, utility
wires, manhole covers, or other
industrial structures, if possible.
If the DIC display does not show a
heading, for example, N for North,
or the heading does not change
after making turns, there may be a
strong magnetic field interfering with
the compass. Interference may be
caused by a magnetic antenna
mount, magnetic note pad holder,
or any other magnetic item. Turn off
the vehicle, move the magnetic
item, then turn on the vehicle and
calibrate the compass.
Compass Calibration Procedure
1. Before calibrating the compass,
check that the compass is set to
the correct variance zone. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press until Press
Calibrate Compass displays.
3. Press to start the compass
calibration.
4. The DIC will display Calibrating
Drive In Circles. Drive the
vehicle in tight circles at less
than 8 km/h (5 mph) to complete
the calibration. The DIC will
display Calibration Complete for
a few seconds then returns to
the Press
Compass display.

Clock

The analog clock is located on the
instrument panel above the radio.
The clock is not connected with any
other vehicle system and runs by
itself. To adjust the clock:
1. Locate the adjustment buttons
directly below the clock.
2. Push and release the right
adjustment button to move the
clock hands forward or the left
adjustment button to make the
To
clock hands go backward.
Holding either button down will
cause the clock to advance
faster. Release the button before
the desired time is reached.
3. Push and release either button
to adjust the time by one minute
increments.
To Calibrate