Completing Your Installation With Or Without A Light Fixture - Hunter 42624-01 Installation And Operation Manual

7 • Completing Your Installation With or Without a Light Fixture
Steps 7-1 – 7-3
Housing
Assembly
Screw
10
Step 7-4
Hunter Fan Company
Your Hunter fan comes with an integrated light fi xture assembly and an
optional switch housing cap and plug button. Th is feature gives you the
option of installing the fan with OR without the included light fi xture.
Th e steps below direct you whether or not you are installing a light
fi xture.
WARNING: Use only the light fi xture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8" housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
Upper
Switch
7-4. Turn the housing counterclockwise until the housing assembly
Housing
screws are fi rmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8" screw into the housing. Tighten
all three screws fi rmly.
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fi xture falling.
7-5. If you want to install the light fi xture, proceed with step 7-6 on
page 12 now.
If you do not want to install the light fi xture, you need to
uninstall it now. See "Uninstalling the Light Fixture" on page 11.
Once you have uninstalled the light fi xture, continue with step
7-6.
CAUTION: Make sure the upper switch housing is securely
42624-01 • 12/01/06