Keyswitch Arming - Paradox 1686V User Manual

Exit and Regular Arm: Press and hold the [ ] button
ENTER
for 3 seconds (see note on page 19) to start the Exit Delay
(see page 13). When the Exit Delay elapses, the system will
switch to Regular arming (see page 14).
Exit and Force Arm: Press and hold the [ ] button
FORCE
for 3 seconds (see note on page 19) to start the Exit Delay
(see page 13). When the Exit Delay elapses, the system
will switch to Force arming (see page 16).
4.7.4 One-Touch Force Arming
Press and hold the [ ] button for 3 seconds (see note
FORCE
on page 19) to bypass any open Force zones. For details
on Force arming, refer to page 16.
4.7.5 One-Touch Bypass Programming
Press and hold the [ ] button for 3 seconds (see note on
BYP
page 19) to access Bypass Programming Mode (see
page 17).

4.8 Keyswitch Arming

A keyswitch can be used to arm and disarm the system. A
keyswitch is assigned to and programmed to Stay arm (see
page 15) or Regular arm (see page 14) a specific partition.
A keyswitch can be Maintained or Momentary.
To arm the system using a Maintained keyswitch, set the
keyswitch to the ON position. To disarm the system set the
keyswitch to the OFF position.
To arm the system using a Momentary keyswitch, set the
keyswitch to the ON position then turn it back to the OFF
position. Repeating this sequence will disarm the system.
20 User's Guide