Start-Up Sequence Sit-Ipi Gas Valve; Section 9: Operation - Montigo L52DF Installation & Maintenance Manual

Proflame SIT Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
A. This appliance is equipped with an ignition system that lights the
pilot burner automatically. Do not attempt to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier than air
and will settle on the floor.
What To Do If You Smell Gas:
■ Do not try to light any appliance.
■ Do not touch any electrical switch; do not use any phone in your
building.
■ Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the Fire Department.
1. STOP! Read the safety information above on this label.
2. Remove the lower Horizontal access panel.
3.
Turn Incoming gas valve to the ON" position.
4.
Wait 5 minutes to clear out any gas. If you smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't smell
gas, go to the next step.
5.
Turn wall switch "ON".
6.
If the Fireplace does not light, the System will cycle through two
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
1.
Turn off remote switch.
2. Remove the lower Horizontal access panel.
3. Turn the incoming gas control valve to "Off".
XG0181 - 042811
Operation
with American Flame Electronic Ignition
XW2008
Lighting Instructions:
Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)
To Turn Off Gas To Appliance:
WARNING
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand, don't try
to repair it, call a qualified service technician. Force or attempt to repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system, and any gas control which
has been under water.
trials, (one minute audible clicking, thirty seconds of silence, and
then another one minute of audible clicking).
7. After completion of the information in the Troubleshooting section,
Repeat step 5.
8. If the system will not function correctly, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician or gas
supplier.
EV1 (Pilot
burner)
Gas "In"
Incoming Gas
Line, Shut-off
Valve
4. Replace the lower Horizontal access panel.
L42DF* Indoor Gas Fireplace
Models
L42DFnI
L42DFLI
EV2 (Main
burner)
Pilot Adjust Screw
Gas "Out"
To fireplace Main
burner
Page 23