Samsung ACC2400C Owner's Instructions & Installation Manual page 58

Setting Up Option Switches (Cont.)
58
E-
Original Position of Option Switches
The option switches are preset by the manufacturer. Refer to the table
below, if necessary.
Option Place Component No.
Rotary Digital Switch(SW1)
Main PCB in the
DIP Switch(SW2)
indoor unit
Jumper Wire(SW05)
Sub PCB in the indoor unit
CN20 Connector
Wired Remote Controller DIP Switch(DS01)
DIP Switch(DS01)
Centralized Controller
Transmitter Rotary Digital Switch(DS01)
N o t e Before setting up the options, always make sure
N o t e
that you have switched off the main power.
After adjusting the options, you should supply the
power. Otherwise, the options will not be applied.
State
0
ON
SHORT
Connected
OFF
OFF
0