Removing The Front Panel; Attaching The Front Panel; Resetting The Microprocessor; About The Demo Mode - Pioneer DEH-P6000UB Operation Manual

Section
01 Before You Start

Removing the front panel

1 Press and hold OPEN to open the front
panel.
2 Slide and remove the front panel to-
ward you.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3 Put the front panel into the provided
protective case for safe keeping.

Attaching the front panel

1 Make sure the inner cover is closed.
2 Replace the front panel by clipping it
into place.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
8
En
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET with a pen tip or other
pointed instrument.
RESET button

About the demo mode

This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing BAND when power to this
unit is turned off while the ignition switch is
set to ACC or ON cancels the reverse mode.
Press BAND again to start the reverse mode.