Porter-Cable CPF6020 Instruction Manual page 9

Accessories for this unit are available at the store the unit was purchased.
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 3/8" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove unit from carton and discard all packaging. NOTE: Save all parts
bags.
Assemble Handle
1. To make installation easier,
submerge handle grip into
warm soapy water. Remove
handle grip from soapy water
and slide onto handle.
2. Insert the handle inside the
compressor saddle and line up
the two bolt holes on each
side.
3. Install the four screws, two on
each side.
4. Tighten securely.
Assemble Wheels
compressor will have a tendency to tip.
1. Attach wheels with shoulder bolts and nuts as shown. NOTE: Place the
bolts in the bottom hole of the wheel bracket.
2. Tighten securely. NOTE: The outfit will sit level if the wheels are properly
installed.
and down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the screws provided as shown in previous figure.
2. Tighten securely.
ACCESSORIES
ASSEMBLY
Handle Grip
It will be necessary to brace or support one side of the
outfit when installing the wheels because the
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up
9- ENG
Screw
Handle
Nut
Wheel
Shoulder Bolt
Rubber Feet
Screw
D26348