Replacement Parts - Electrolux 115 V 60 Hz Washer Owner's Manual

Hide thumbs

Table of Contents

Connecting drain and electrical

Form a "U" shape on the end of the drain hose with the hose

pointed toward the drain. Place the formed end in a laundry

tub or a standpipe and secure with a cable tie provided in the

enclosure package.

Place the hook end of the drain hose in the drain opening.

Secure the drain hose with the cable tie (provided in the

enclosure package) to the standpipe, inlet hose, laundry tub,

etc. so the hose does not pull out from the force of the water.

The standpipe inside diameter must be 1-1/4" (3.2

cm) minimum. There must be an air gap around the drain hose

in the standpipe. A snug hose ﬁ t can cause a siphoning action.

Check to ensure the power is off at circuit

breaker/fuse box before plugging the power cord into outlet.

Plug the power cord into a grounded outlet.

Grounding type

wall receptacl

ll receptacle

Po Power cord with

wer cord with

3-prong

3-prong gr grounded plug

Turn on the power at circuit breaker/fuse box.

Carefully slide the washer to its ﬁ nal position. Recheck for level

and rock corners for stability.

Read the Use & Care Guide provided with the washer. It

contains valuable and helpful information that will save you

time and money.

Run the washer through a complete cycle, checking for water

leaks and proper operation.

If you have any questions during initial operation, please review

the "Service Prevention Checklist" in your Use & Care Guide

before calling for service.

Place these instructions in a location near the washer for future

reference.

A wiring diagram and technical data sheet are

located inside the washer console.

If replacements parts are needed for your washer, contact the

source where you purchased your washer.

Do not, under

Do not,

under

an any cir

y circumstances,

cumstances,

cut, remo

cut,

remove ve,

or bypass th

or b

ypass the

gr grounding pr

ounding prong.

ong.

ounded plug