6.2 Pressure switch adjustment
Warning: Disconnect the electricity supply before
undertaking this operation.
6.3
Pump pressure calibration
NB: The correct pressure is of 8-9 atm.
Warning !!
When the machine is new the filter-holder sump may
not be aligned (perpendicular to the machine itself)
as shown in the figure at the side, however this does
not effect the efficient function of the same.
After a short period of use the sump will gradually
settle into a correct position.
IMPORTANT: N°2 under-tile packings with are thinner (8.1mm
) than that fitted as standard are included. These packings may
be used in the event of difficulty with insertion of the filter holder.
6.4 Filters for coffee machine
WGANF08/002/B
WGANF08/004/B
WGANF08/005/B
WGANF08/009/B