Check Or Replace Your Filter; Replace The Uvc Bulb - Hunter 30836 Owner's Manual

Total air purification system

Hide thumbs Also See for 30836:

Manual de usuario (14 pages)

Table Of Contents

Table of Contents

5. If the Pre-Filter needs to be cleaned, It may be

submerged in warm soapy water to clean. Gently lift

and submerge the filter several times to clean.

6. When complete, rinse the filter with warm water and

allow to dry completely.

Note: Wet parts placed into the unit can cause damage

to the filters and or the motor of the Air Purifier.

1. Turn the Air Purifier off and disconnect from the wall.

2. Remove the rear grill on the back of the unit by

pressing the tab at the top of the unit, under the

handle and pull the rear grill outward. Figure 7.

3. Remove the HEPA Filter from the unit.

4. Check the Filter for particle build-up.

5. The HEPA filter should be removed every 12 months

of use and matched to the color indicator on the inside

of the filter compartment. When the filter matches the

dark, charcoal gray indicator, it should be replaced.

The UVC light should be replaced once yearly. Follow

these instructions to remove and replace the UVC bulb.

1. Unplug the unit from the wall outlet and turn it over, so

the bottom of the unit is visible.

2. Using a small phillips screwdriver remove the 2 screws

holding the UVC Cover in place. Figure 9.

3. Gently push the tab on the UVC Cover and lift it away.

Figures 9. and 10.

4. Locate the UVC Bulb Carrier and turn it 45

clockwise. Figure 11.