Table of Contents
Advertisement
8
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower holes, using one 1/4-20x1½"
screw and 7mm lock washer on each side, shown A. In the cart, secure upper back panel to lower back panel using
one 1/4-20x1/2" screw and 7mm lock washer, shown B.
1/4-20x1½"
screw
Qty.4
9
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia, making sure "OFF" is on the top. Attach using two #8-32x3/8" screws and 4mm lock washers. Press sideburner
control knob onto valve stem.
Lock washer
Screw
Valve stem
Screws and Washers
removed from valve bracket
20 • 464222409
screw and 7mm lock washer on each side. In upper holes, using one
7mm Lock washer
1/4-20x1/2"
Screw
Qty.5
Qty.1
Upper back panel
Lower back panel
Sideburner
valve bracket
1/4-20x1½"
7mm
screw
lock washer
4mm lock washer
#8-32x3/8" screw
Qty.2
Qty.2
Sideburner
shelf fascia
Control knob bezel
1/4-20x1½"
A
7mm
lock washer
1/4-20x1½"
screw
B
Upper back panel
7mm
1/4-20x1/2"
lock washer
screw
Note: Use upper and lower
holes on fascia to
attach bezel
Valve stem
4mm
lock washer
#8-32x3/8" screw
Sideburner control knob
Advertisement
Table of Contents
Troubleshooting
