Waypoints, Routes And Tracks; Save, Edit, Or Delete A Waypoint - Humminbird ] 981 Installation & Operation Manual

98x_Manual_531376-1_A.qxd 2/23/2005

WAYPOINTS, ROUTES AND TRACKS

Waypoints are stored positions that allow you to mark areas of interest or navigation
points. Your 900 Series™ can store up to 3000 waypoints.
Waypoints, Routes and Tracks
1
2
11
3
4
5
6
7
1 Depth
HDG: Direction that boat is traveling
2
relative to North Reference
BRG: Direction to Destination Waypoint
3
Relative to North Reference
XTE: Cross Track Error. Distance of Boat
4
from Route
5
DTG: Distance to Go to Waypoint
11:40 AM Page 48
(987c SI Combo models only)
8
9
10
TTG: Estimate of Trip Time to Destination Waypoint 6
7
Speed of Boat
Waypoint 8
9
Route
Off-Course Alarm Limits 10
11
Map Scale
Routes link two or more waypoints together to create a path for navigation, and are
used in trip planning. You can link individual waypoints together by using the GOTO
key. A route represents your intended navigation and shows the shortest path from
each waypoint to the next. As you travel a route, staying on the route line is the most
efficient way to get to your destination, although you should always look out for
obstacles not shown on the chart. Your 900 Series™ can store up to 50 routes that can
each contain up to 50 waypoints.
Tracks consist of detailed position history, and are displayed as a breadcrumb trail of
trackpoints. The Current Track shows the position history since the unit was powered
up (maximum of 20,000 trackpoints displayed). You can clear the Current Track or save
it at any time. Your 900 Series™ can store up to 50 saved tracks, each containing
20,000 trackpoints. The current track represents your actual path so far.

SAVE, EDIT, OR DELETE A WAYPOINT

Save your current position as a waypoint: On any view, press the MARK key to save the
current position of the boat as a waypoint.
Save the cursor position as a waypoint: On the Chart or Combo view, use the Cursor
key to designate the position you want to save as a waypoint. Then press the MARK key
to save the marked position as a waypoint.
Save a position from the sonar history: On the Sonar view, use the Cursor key to point
to a feature in the sonar history (also called the Sonar Saver feature). Press the MARK
key to create a waypoint at the location where that sonar reading was taken. The new
waypoint will also record the depth at that location.
NOTE: When you save a waypoint by any of these methods, a numerical waypoint name is
automatically assigned. You can edit the waypoint information later to give it a different
name and select an icon to represent it (see Waypoint submenu on the Navigation Main
Menu Tab).
42
(987c SI Combo models only)