H Battery Installation - Power Wheels H9800 Owner's Manual With Assembly Instructions

H
IMPORTANT! Use only a Power Wheels
rechargeable battery. Use of any other battery will damage your
vehicle. Make sure that you charge the battery for at least 18 hours
using the enclosed Power Wheels
your vehicle for the first time. Charge the battery for at least 14
hours after each use of the vehicle. Never charge the battery longer
than 30 hours. Failure to follow these instructions may damage your
battery and will void your warranty.
1
• Press the tab under the back edge of the seat and lift to remove
the seat.
2
• Lift the battery clamp to access the battery compartment.
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push firmly
to join.
12
BATTERY INSTALLATION
12 volt lead-acid
®
12 volt charger before operating
®
Seat
Motor
Harness
Connector
Battery
3
• Lift the battery clamp and slowly lower the battery into
the compartment.
4
• Fit the tab at the front of the seat into the slot in the vehicle near
the handlebars .
• "Snap" the tab at the back of the seat into the slot in the rear of
the vehicle .
H9800pr-0920 H9800pr-0920