Bond GSF3016 Owner's Manual page 10

Step 6 (Doors and Storage Basket Assembly)
a) Insert the bottom pin of right door (Z) into the pre-drilled hole
on the cart bottom panel (R).
b) Push down the top pin of right door and insert it into the
pre-drilled hole on the upper cart front beam (O).
c) Repeat the procedure for the left door (Y) assembly.
d) Loosen the two pre-installed bolts on left door and allow 1/4
bolt's length to extend from the door. Align the holes on the
storage basket (X) with the extended two bolts on the door.
Push down on the storage basket until it locks into place.
Step 7 ( Install body assembly)
a) Place the body assembly (A) on the cart assembly.
b) Align the holes on cart front legs with the holes on the
body assembly (A), then insert one bolt (AA) with one
spring washer (CC) and one flat washer (DD) into each
hole. T ighten by hand until secure.
c) Align the hole on each back leg with the holes on body
assembly. Insert one bolt (AA) with one spring washer
(CC) and one flat washer (DD) into each hole. T
hand until secure.
d) Go back and tighten all bolts using the screwdriver
provided.
GSF3016E
Owner's Manual
ighten by
9
Step 8 (Install side bar tool hanger)
a)
Turn over the left side shelf (G), then align
on the end of side bar tool hanger (H) with the
holes on the left side shelf (G).
b) Insert one bolt (AA) with one spring washer (CC)
and one flat washer (DD) into each pre-drilled
hole. Tighten bolts using the screwdriver
provided.
the holes