Electrolux GLDB957JB series Service Manual page 65

† Color Code
… v r

BK......................... Black
Q
% % T
r
BK-W...........Black/White

à T
BU............................Blue
#
( ! $
PK............................Pink
v p
" R...............................Red
! #
R-BK...............Red/Black
#

) Ã
R-Y................Red/Yellow
$
 I
‡ … ‚
VIO.........................Violet
à Q
) Ã
 h W...........................White
W-BK...........White/Black
h
p
 I
€
y r
The water/service test is a special function
initiated from the power failure mode or idle
mode.
While in power failure mode - simultaneously
press the NO HEAT DRY and START/CANCEL
pads for 1 1/2 seconds.
The dishwasher will then step through the test
cycle per the chart. Pushing the START/CANCEL
pad will advance the dishwasher to the next step.
While in idle mode - simultaneously press
WASH BOOST & START/CANCEL pads for
1 1/2 seconds.
Operation
Water/Service Test
9v†ƒyh’Ã8‚qr†ÃSrhq‚ˆ‡
@I DIB
LO ....Low liquid in the rinse aid dispenser
PF .....A power failure has occurred X6 CDIB
SDI DIB
HO ....Water heating delay
9S`DIB
8G@6IÃ
CL .....Close and latch the door
PQUDPIÃG@9†ÃAyh†uvt
'01-09' ....Hour(s) delay before start
U6UV ÃG@9†ÃAyh†uvt
9v†ƒyh’Ã8‚qr†ÃG@9
---------------------- Turbidity sensor is checking the condition of the wash/rinse water.
No sensing for SAVER CYCLE.
----------------------Wash portion of cycle.
----------------------- Rinsing portion of cycle.
------------------------ Drying portion of cycle.
-------------------------Shows completion of cycle. Indicator light will switch off when door is opened.
-- WASH BOOST and NO HEAT DRY LED's flashing indicates power failure has occurred. Press
START/CANCEL pad and reselect desired options and cycle.
-- The STATUS LED's that are lit when the door is opened will flash. Close door.
v…vtÃ9vht…h€
*TURBIDITY
SENSOR