Switching On For The First Time: Installing The Software; Switching On Monitor And Device - Fujitsu ESPRIMO Q900 Operating Manual

Preparation for use

Switching on for the first time: installing the software

If the device is integrated into a network, the user and server details as well as the network protocol
are required during the software installation. Contact your network administrator if you have any
questions about these settings.
When you switch on the device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
Once the installation has been started the device must not be switched off, unless the
!
installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents of the hard disk
must be completely restored.
You may need the licence number for Windows during the installation. The licence number is located
on a sticker on your device.

Switching on monitor and device

Your ESPRIMO features a new technology which allows you to boot your system simply
i
with a light touch of your finger: You no longer need to press the power button down to
activate your system. Just touch the button with your finger and the system starts to boot
automatically.
► Switch the monitor on (see the operating manual for the monitor).
1
► Touch the ON/OFF switch on the front of the device for approximately half a second.
The power indicator glows white and the device is started.
12
1 = ON/OFF switch with power indicator
Fujitsu Technology Solutions