CYBEX 515T Owner's Manual page 91

Cybex Sport+ Treadmill Owner's and Service Manual
6. Route the new heart rate cable.
A. Connect the double connector into the right side of the heart rate board. See Figure 25.
B. Locate the short and long side of the heart rate
cable.
C. Route the short cable end to the left (from
treadmill user's viewpoint) and the long end to
the right.
D. Place the cable behind the handrail and tie with
four wire ties in the locations they were removed
in step 5D.
E. Fold the each cable and place it into the hole
that leads to the grip. See Figure 27.
F. Push each wire out a hole (red out the front hole
and black out the back hole). See Figure 27.
7. Secure the new plastic housing.
A. Slide an o-ring on each handrail and roll it over
the wires so that it is positioned just after the
hole where the wires emerge. See Figure 27.
B. Remove the protective paper from the loose
pieces double-sided tape and stick each one
between two small holes in the handrail. See
Figure 28.
C. Position each set of plastic housing so that the
grooves fit together snugly. NOTE: If the grooves
don't fit and the housing gets taped down in the
wrong position pulling it up will destroy the tape.
Do not let the plastic housing touch the double-
sided tape until step 7E.
D. Place each plastic grip near the handrail and pull
each wire through a rectangular hole. See Figure
29. NOTE: Don't let the wires slip back into their
holes.
E. Fit the three plastic parts in position (the housing (2) and the
cap (1)) and continue holding all plastic parts through the next
step. See Figure 29.
F. While being careful not to overtighten and crack the housing,
place the nuts in their holes and secure them with the bolts.
NOTE: It is easier to place the nuts on the top and the bolts
from the bottom. See Figure 30.
Black Wire
(Back)
O-Ring
Cable
Enters
NOTE: Front is from treadmill
Hole
user's viewpoint.
Figure 27
Small Holes
Figure 28
Figure 29
Nuts
Figure 30
Red Wire
(Front)
Double-sided
Tape
Cap
Double-sided
Tape
Wire Through
Rectangular
Hole
Bolts
Service
Page 7-33