Enable Atis Functionality (Atis Func); Dsc Functionality Options (Dsc Func); Response Type To Ll Polling Calls (Ll Reply) - Simrad RS12 VHF User Manual

4-5-3 Enable ATIS Functionality (ATIS FUNC)

ATIS functionality can only be activated if an ATIS MMSI has been entered. See 4-5-1.
DSC SETUP
INDIV REPL▲
ATIS MMSI
►ATIS FUNC ▼
1. Select DSC SETUP, then ATIS FUNC.
Note: It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. If you
want to activate ATIS, you must first switch DSC off. A note on the LCD will remind you if DSC
is already ON.
Select ON to enable the ATIS functionality - DSC must be turned off first. The ATIS
2.
annunciator appears on the screen.

4-6 DSC functionality options (DSC FUNC)

DSC functionality can be disabled but this is not recommended unless you are going to turn
ATIS on.
DSC SETUP
GROUP SETU▲
INDIV REPLY
►DSC FUNC ▼
1. Select DSC SETUP, then DSC FUNC.
Note: It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. If you
want to activate DSC, you must first switch ATIS off. A note on the LCD will remind you if ATIS
is already ON.
2. Select ON to enable the DSC functionality - ATIS (if applicable) must be turned off first. The
DSC annunciator appears on the screen.
There are two annunciators on the screen to show you the current mode: if the DSC annun-
ciator is shown, DSC is operational, if the ATIS annunciator is shown, ATIS is operational.

4-7 Response Type to LL Polling Calls (LL REPLY)

You can set the radio to respond to an LL polling request in one of three ways:
AUTO
automatically replies to any incoming LL polling requests from any of your
buddies.
MANUAL
choose to manually reply to any incoming buddy polling requests.
OFF
ignores all incoming buddy LL polling requests.
ATIS FUNC
►ON
OFF
DSC IS ON
DSC FUNC
►ON
OFF
ATIS IS ON
Simrad - RS12 Operation and Installation Instructions
ATIS
29