Gps Alert Options (Alert); Gps Simulator (Simulator); Reset To Factory Defaults (Reset) - Simrad RS12 VHF User Manual

2-5-7 GPS Alert Options (ALERT)

The GPS alert is usually set to ON (on) so that if the GPS navigation receiver is disconnected,
the alarm sounds.
SETTING
LL DISPLY ▲
COG/SOG
►GPS ALERT

2-6 GPS Simulator (SIMULATOR)

The GPS Simulator is set to OFF whenever the radio is switched ON, or whenever real GPS
data is available through the COM port. However, if you want to test it, turn it on.
MENU SELECT
DSC SETUP ▲
RADIO SETUP
►GPS SIM ▼
Important: It is not possible to send a DSC transmission when in Simulator mode.

2-7 Reset to Factory Defaults (RESET)

Use this setting to return every setting to the factory defaults, except all MMSI settings,
entries in your buddy list and any edited channel names.
MENU SELECT
RADIO SETU▲
GPS SIM
►RESET
1. Select RESET. The radio asks for confirmation.
2. Select YES to reset the radio and return to the menu.
20
GPS ALERT
►ON
OFF
1. Select GPS SIM, then select ON (on) or OFF (off ) as desired.
Whenever the GPS Simulator is turned ON (on), simulated
Speed Over Ground (SOG), Course Over Ground (COG), and LL
position appear on the screen. This data is updated automati-
cally during the simulation.
RESET RADIO
ARE YOU SURE
►YES
NO
Simrad - RS12 Operation and Installation Instructions
1. Select GPS/DATA, then SETTING.
2. Select GPS ALERT.
3. Select ON (on) or OFF (off ) as
desired.